Ver.CHAPTER 7. WLAN Additional Services© SAMSUNG Electronics Co., Ltd. page 230 of 4962600-00FK1RGA4 3.0AirMove Configuration Item Descriptionscan interleaving time Configures the scanning interval of a wireless terminal.- OPTION: scan-time-interleave- OPTION_DETAIL: Time (ms)Service time in scanning period Configures a period when an wireless terminaltransmits/receives an actual data traffic after scanning.- OPTION: scan-time-service- OPTION_DETAIL: Time (ms)scan report level Configures the threshold of a scan report that will betransmitted from an AP to the APC.- OPTION: scan-report-level- OPTION_DETAIL: scan report level (dBm)Numbers of handover scanattempts per channelConfigures the scanning times of a wireless terminal perchannel.- OPTION: number-of-proreq- OPTION_DETAIL: Number of timesNumber of channels for whichscan is attemptedConfigures the number of channels a wireless terminal willscan at a time.- OPTION: number-of-channel- OPTION_DETAIL: Number of channelsscan trigger level RSSI intensity at which a wireless terminal starts channel scanning- OPTION -trigger-level- OPTION_DETAIL: RSSI (dBm)station decision delta Configures the threshold of RSSI difference, measured in awireless terminal, between a serving AP and a target AP. If thethreshold is exceeded, a wireless terminal performs itshandover.- OPTION: station-decision-delta- OPTION_DETAIL: Threshold (dBm)An example of using the command for each configuration item is as follows:WEC8500/configure# handover opmode APPWEC8500/configure# handover buffered-forwarding enableWEC8500/configure# handover decision-delta 10WEC8500/configure# handover scan-time-channel 10WEC8500/configure# handover scan-time-interleave 1000WEC8500/configure# handover scan-time-service 200WEC8500/configure# handover scan-report-level -90WEC8500/configure# handover number-of-proreq 3WEC8500/configure# handover number-of-channel 4WEC8500/configure# handover scan-trigger-level -65WEC8500/configure# handover station-decision-delta 10To check the configuration information, use the ‘show handover configuration’ command.
