WEC8500/WEC8050 (APC) Operation Manual v10.1 100©Samsung Electronics AmericaMatch Criteria Descriptionaccess-group match access-group [ACCESS_GROUP_NAME]class match class [CLASS_NAME]COS match cos [COS_VALUE/any]destination IP range match dst ip range [A.B.C.D] [A.B.C.D]IP match ip dscp [DSCP_VALUE/any]match ip precedence [IP_PRECEDENCE_VALUE/any]match ip tos [TOS_VALUE/any]protocol match protocol [PROTOCOL_VALE/any]source IP range match src ip range [A.B.C.D] [A.B.C.D]5 Exit the Class-map mode.o exit6 To check the configuration information, use the ‘show running-confignetwork’ command.Policy-map Configuration1 Go to the fqm mode to configure the configure ACL rule of CLI.APC# configure terminalAPC/configure# fqm-mode2 Go to policy-map mode. To delete a policy map, enter ‘no’ parameter infront of the command.o policy-map [POLICY_MAP_NAME]o no policy-map [POLICY_MAP_NAME]3 By using the class name configured in the class-map, go to the inputmode.o class [CLASSMAP_NAME]4 Configure a policy-map using the following command:[Bandwidth to a class of traffic]o bandwidth percentage [PERCENTAGE_VALUE][Configure set action]o mark cos [COS_VALUE]o mark ip dscp [DSCP_VALUE]o mark ip precedence [PRECEDENCE_VALUE]o mark priority [PRIORITY_VALUE][Configure police action]o police trtcm cir [1-1000] cbs [125000-125000000] pir [1-1000] pbs[125000-125000000] conform-action (drop|(dscp [0-63]|ip [0-7])|transmit) exceed-action (drop|(dscp [0-63]|ip [0-7])|transmit)
