WEC8500/WEC8050 (APC) Operation Manual v10.1 341©Samsung Electronics Americao calibration pc [NUMBER]o calibration others [NUMBER]Parameter DescriptionNUMBER RSSI calibration value (-dbm)• Default value: 0 dbm7 To exclude stations where the traffic occurs from load balancing, thefollowing option must be set (Default: no idle-station):o idle-station8 The following option must be configured to use the HandOver functionof Smart Service Link (default: no ssl-ho):o ssl-hoSetting AP Group ParameterStation-based/AirTime-based Adaptive Load Balancing must set operating parameters tothe radio of the corresponding AP group because it operates in a radio unit of the APgroup.Configuration using CLITo set AP group parameters, execute the command as follows:1 Go to the load-balancing configuration mode in configure AP Groupof CLI.APC# configure terminalAPC/configure# ap-group lbAPC/configure/ap-group lb# load-balancingAPC/configure/ap-group lb/load-balancing#2 Go to the radio to perform the Station-based Adaptive Load Balancingfunction.APC/configure/ap-group lb/load-balancing# radio 1APC/configure/ap-group lb/load-balancing/radio 1#3 Activate load balancing in the corresponding radio.o enable4 Set the criteria of operation at the Load Balancing function.o CriteriaParameter DescriptionCRITERIA • station: Station based Adaptive Load Balancing• sticky: only sticky Station based Adaptive Load Balancing• airtime: AirTime based Adaptive Load Balancing5 Set the interval to attempt at the Station-based Adaptive Load Balancing
