WEC8500/WEC8050 (APC) Operation Manual v10.1 340©Samsung Electronics AmericaStation-based/AirTime-based Adaptive LoadBalancingStation-based Adaptive Load Balancing performs load balancing based on the number ofstations and RSSI in an individual radio unit of the AP group.AirTime-based Adaptive Load Balancing performs load balancing based on the channelutilization per station and interference in an individual radio unit of the AP group.Configuring Basic Function and Setting Load Balancing Parameters of AP Group areavailable and the settings of the load balancing parameters in individual APs are availableto apply a different value set only for a specific AP.Basic Setting of Load BalancingStation-based/AirTime-based Adaptive Load Balancing operates only when it is enabledin the setting of the basic functions and configures options applied to the overall functionoperation.Configuration using CLITo configure the basic function, execute the commands as follows:1 Go to the configure load-balancing configuration mode of CLI.APC# configure terminalAPC/configure# load-balancingAPC/configure/load-balancing#2 Activate the Load Balancing function.o enable3 If a function of distributing stations uniformly among APs is necessary,activate the Active Load Balancing function. This is not applied toAirTime-based Load Balancing. (Default: no active).o active4 To activate the Active Load Balancing function, set up the interval forattempting to distribute uniformly.o interval [NUMBER]Parameter DescriptionNUMBER Interval for performing active load balancing (sec)5 To allow load balancing among APs which use the same channel, setthe following option (Default: no allow-channel):o allow-channel6 To calibrate the RSSI value depending on types of stations, thecalibration value must be set.o calibration mobile [NUMBER]
