WEC8500/WEC8050 (APC) Operation Manual v10.1 295©Samsung Electronics AmericaWEC8500/configure/rrm/80211a/dpc# periodic-interval [value]7 Execute the following command to change the Tx Power range which isautomatically set by DPC. The default minimum is 3 and the defaultmaximum is 30 for both 80211a and 80211b.WEC8500/configure/rrm/80211a/dpc# txPower min [value] max [value]8 Check the settings using the ‘show rrm config-summary’ command.Configuration using Web UIIn the menu bar of , select and then select the <802.11a/n/ac> or <802.11b/g/n> menu in the sub-menus.Enable or disable the DPC in the SERVICE field in Dynamic TX Power Control.Figure 207. DPC SettingsDCS ConfigurationThis section describes the setting options of the DCS function which automatically setsthe channel of the AP.Configuration using CLI1 Go to configure rrm configuration mode of CLI.WEC8500# configure terminalWEC8500/configure# rrm2 Go to the wireless section where you want to change the settings.WEC8500/configure/rrm# 80211a3 Set the DCS function. Enter the dcs setting mode and set it to ‘enable’.Use the ‘no’ parameter to disable the mode. The function operates onlywhen the RRM is set to 'Enable'.WEC8500/configure/rrm/80211a# dcsWEC8500/configure/rrm/80211a/dcs# enable4 Configure whether to apply the DCS-DPC joint algorithm. If the ‘no’parameter is selected, the configuration is cleared.
