WEC8500/WEC8050 (APC) Operation Manual v10.1 6©Samsung Electronics AmericaLED Status DescriptionRed Power is turned off or a fault occurred while the power module 2is installed.Off Power module 2 is not installed.Console Port (RS232C)A console port is used to check the operational status of WEC8500 or for input throughthe CLI. Its basic requirements are as follows:• Baud rate: 115200 bps• Character size: 8 characters• Parity: None• Stop bit: 1, Data bit: 8• Flow control: NoneManagement Port (1 GE UTP)The WEC8500 provides a 10/100/1000BASE-T port (RJ-45) for management purpose.It is working in 10/100 Mbps half duplex/full duplex mode or in 1000 Mbps full duplexmode. Because it supports the automatic MDI/MDI-X function, you can use a straight-through cable for all the network connections to a PC, server, switch, or network hub.Figure 5. Management Port ConfigurationConfiguration item Status DescriptionLED Green Turned on for link connectionOrange Blinking for data exchangeConnector - Connector for UTP cable connectionWhen connecting a cable to the management port, make sure to check if the cablecomplies with the 10 BASE-T, 100 BASE-TX, or 1000 BASE-T.• Cable type: UTP or STP cable using RJ-45 connectoro 10 BASE-T: Category 3 or highero 100 BASE-TX: Category 5 or highero 1000 BASE-T: Category 5 or higher (Category 5e or higher isrecommended)• Isolate from wireless frequency disturbing waves• Shut down electrical surgeLEDConnector
