WEC8500/WEC8050 (APC) Operation Manual v10.1 26©Samsung Electronics AmericaInitial Setup WizardOverviewThe initial setup wizard aims to finish the basic settings by guiding the settings requiredfor the basic WLAN service in order when the APC is installed. It supports only the basicsettings to operate the WLAN service and the settings which are additional or are notfrequently used are not supported here. They must be made through the general WECscreen.ConnectingConnecting ConditionIf being connected to the WEC as web UI at the factory reset state or while there is noWLAN, the APC system is connected to the Initial Setup Wizard instead of the generalWEC screen.Connecting at the Factory Reset StateThe connection at the factory reset state is available through the management port.1 Connect the Ethernet cable to the management port and then to the PC.2 The default IP address of the management port is 192.168.1.2. Afterconfiguring the IP address of the PC fit for the bandwidth, open the webbrowser.3 Enter 192.168.1.2 in the address bar of the browser to access.Access while the IP Address is SetIf the IP address of the APC is set, check whether the APC and the PC are networkedand then open the web browser before accessing the IP address.How to UseIf the access to the APC is made through the web browser, follow the login procedure asshown in ‘Web UI Connection’ part in ‘Basic System Configuration’ chapter. You can seethe welcome message by connecting to the wizard as shown below:
