UniPOS IFS7002 Instruction Manual

Also see for IFS7002: Instruction manual Service instructions for the staff Service instructions

Contents

UniPOS IFS7002 Instruction Manual Manual pdf 26 page image

UniPOS IFS7002 two signal loopsInstruction Manual Page 26Revision 11/01.17 Of 14510. Disabled component10.1. DescriptionThe fire control panel enters Disabled component after a manual operation, disabling a specificcomponent – a fire alarm zone, addressable device or monitored output. The condition is handled viaInformation and Control screens. A disabled zone is not monitored for activated fire detectors or faultcondition. A disabled addressable device is not activated (if it is an executive device) and is notmonitored for activation (if it is a fire detector) or fault condition. A disabled monitored output isswitched off (the executive device is not able to respond) and is not monitored for fault condition.Where disabled zones, disabled addressable devices or disabled monitored outputs are available,the LED indication illuminates and the relevant message is displayed10.2. Indication10.2.1. LED and sound indicationThe condition is indicated by the Common indicator (Disabled component) illuminated incontinuous yellow light.No sound signaling is supported for Disabled component condition.10.2.2. Text messagesIf a disabled component isavailable, a table giving informationon the total number of disableddevices and faults appears on theLCD display. The second line of thetable’s left column displays the totalnumber of disabled components; thesecond line of the table’s rightcolumn – only the number ofdisabled outputs (monitored outputsand addressable output devices):To display the text message foreach fault condition, enterInformation and Control Mode (seesection 12.2.2).10.3. Using the keypadFor Disabled component condition 1 active button is supported. Where the fire control paneloperates in combination of other conditions, their buttons are active too.Press button (Menu) to enter Information and Control Mode.11. Test Mode11.1. DescriptionThe fire control panel enters Test Mode through manual operation setting a fire alarm zone toTest Mode. The condition is handled via Information and Control Screens (see section 12.3.2).Where a fire alarm zone is set to Test Mode, the following changes take effect: Where Fire condition stage I or Fire condition stage II is detected in the zone, sound andLEDs indications, associated addressable, controllable or relay outputs are not triggered; i.e.the fire control panel does not enter Fire Condition; Where Fault condition in a zone is registered, (i.e. fault in any device, integrated in the zone),sound and LEDs indications or the relay output for fault condition are not triggered, i.e. the firecontrol panel does not enter Fault Condition (with the exception of the isolator of a device inthe zone, because it would break the integrity of the loop; in this case a fault in the devicewould be registered, but not fault in the zone);Mode:DAY LOC ActInp 0000FIRE CONTROL PANEL IFS7002UniPOSThu 11 Feb 201011:48:24Faults Total: 00000/00000*Disables Total: 002Failed Outputs: 00000Disabled Outputs: 001