UniPOS IFS7002 Instruction Manual

Also see for IFS7002: Instruction manual Service instructions for the staff Service instructions

Contents

UniPOS IFS7002 Instruction Manual Manual pdf 9 page image

UniPOS IFS7002 two signal loopsInstruction Manual Page 9Revision 11/01.17 Of 145 Maximum number of fire detectors in a loop - 125 Connecting line - two-wire shielded Maximum resistance of a loop - 100 Output resistance of a loop - 20 Maximum consumption of a loop - 120mA4.4. Power loop Connecting line - two-wire Maximum resistance of the loop - 10 Output resistance of the loop - 2 Maximum consumption of the loop - 1A4.5. Monitored outputs Type - potential Еlectrical characteristics - (24±5)V/1A4.6. Relay outputs for fire conditions Type - potential free, switching, Electrical characteristics - 3A/125VAC; 3A/30VDC4.7. Relay output for fault conditions Type - potential free, switching Electrical characteristics - 3A/125VAC; 3A/30VDC4.8. Performance Control over fire alarm loops and monitored outputs for fault conditions (short circuitand interruption) and automatic reset Detection of removed devices in the loops and automatic reset Ability to set the zones in Coincidence Mode Two phases of Fire condition, programmable time for Fire condition stage I,separately for each zone Option to prolong the time period for Fire condition stage I with programmableinspection period, specified for each zone Built-in sounder for fire condition – one tonal, discontinuous, can be switched off Built-in sounder for fault condition – one tonal, discontinuous, can be switched off Built-in real time clock Set of test modes and options for adjustment: Setting the clock; Check ups on light and sound indications; Test of fire alarm zones; Adjustment of outputs and integrated external devices; Programming of parameters and modes of operation; Remote programming of the parameters from distant operator control point; Energy independent archive of registered events with the events type, date and hour– up to 1023 events; Interfaces for communication with external devices - CAN 2.0B and RS-232(directly or via modem).4.9. Indications of registered events Light indication - LED Text messages - LCD display,320 х 240 points, backlit Sound signaling - built-in sounder4.10. Power supply4.10.1. Mains voltage - 220/230V frequency - 50Hz4.10.2. Back up batteries battery type - lead, gel electrolyte number of batteries - 2 pcs connection - serial connection