WAGO-I/O-SYSTEM 750 CoDeSys 2.3 Runtime Environment 103758-874/000-131 WAGO-I/O-IPC-C6ManualVersion 1.0.0Table 54: Addressing exampleI/O Module Input Data Output Data DescriptionType C*750-600End moduleThe passive 750-600 End Module does nottransmit any data.Analog input/output modulesDigital input/output modules*C: Number of the input/output11.5 Installing the Programming System CoDeSys 2.3(WAGO-I/O-PRO CAA)The WAGO target files are installed during the installation of CoDeSys. Thesecontain all device-specific information for the WAGO 750/758 product series.Proceed as described below to install the programming software CoDeSys 2.3 onthe I/O-IPC.1. Insert the CD-ROM "WAGO-I/O-PRO CAA" into your computer drive.2. To install the programming system, follow the instructions that appear onyour screen. A successful installation is indicated by a CoDeSys icon onyour desktop.11.6 The First Program with CoDeSys 2.3This section explains, through examples, the relevant steps required for thecreation of a CoDeSys project. It is intended as a set of quick start instructions anddoes not address the full functional range of CoDeSys 2.3.Further informationsPlease see the manual "Handbook for PLC Programming with CoDeSys 2.3" onthe CD "WAGO-I/O-PRO CAA" (759-911) for a detailed description of the fullfunctional range.11.6.1 Start the CoDeSys Programming SystemStart CoDeSys by double clicking on the CoDeSys pictogram on your desktop orthrough your operating system using your start menu. To do this, click on the"Start" button and choose Program >WAGO Software > CoDeSys for Automation Alliance > CoDeSys V2.3.
