WAGO-I/O-SYSTEM 750 Configuration 79758-874/000-131 WAGO-I/O-IPC-C6ManualVersion 1.0.09.1.9 "HMI Settings" PageOn the "HMI Settings" page, change the graphic resolution for the DVI-Iinterface, configure the touch screen or monitor, and choose between a English orGerman keyboard layout.To save all settings made on the page, click the [SUBMIT] button. The I/O-IPCmust be restarted or reset to apply the settings.Table 35: Description of the Screensaver and Cleanmode parameters on the "HMI Settings" pageScreensaverDisplayIndicates whether the display is switched on or off.off: red cross and text "off"on: green check and text "on"The display can be switched off by the screensaver (after thecorresponding wait time) or explicitly by the user.The current value is queried and indicated cyclically every two seconds onthe web site (this is only queried once in Configtool instead of cyclically).The display can be switched on or off using the [Switch on] or [Switchoff] buttons.These changes are effective immediately.ScreensaverIndicates the status of the Screensaver Function.enabled: green check and text "enabled"disabled: red cross and text "disabled"When the screensaver is turned on (enabled), the touch screen display isturned off after the configured wait time and turned on again followingtouch screen or keyboard entry.When the screensaver is turned off (disabled), the display can only beexplicitly switched on or off by the user (see section "Display").By using the [Enable] or [Disable] buttons, the Screensaver Function canbe immediately activated or deactivated.This does not effect the current status of the display – even if thescreensaver is activated, the status of the display only changes afterpassage of the wait time or pressing on the touch screen/keyboard.Wait time (sec)The "Wait time" parameter is only evaluated if the "Screensaver"parameter has enabled the status. If so, the value indicates the time inseconds after which the screensaver is activated.You can change the wait time by changing the value in the input field andclicking on the [Change] button.The changes immediately effect the next activation of the screensaver.
