56 Connecting the Supply Voltage WAGO-I/O-SYSTEM 750758-874/000-131 WAGO-I/O-IPC-C6ManualVersion 1.0.0Pos: 38.11 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x 750-626 - Überschrift 2 @ 10\mod_1313497552539_21.doc @ 77103 @ 2 @ 17.4 Power supply via 750-626 Filter ModulePos: 38.12 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x Einleitung 750-626 @ 10\mod_1313497568008_21.doc @ 77109 @ @ 1The 750-626 Filter Module is required as soon as a supply line exceeds 3 mbetween the voltage source and the I/O-IPC.Pos: 38.13 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x 750-626 Einleitungsende @ 10\mod_1312442131062_21.doc @ 75871 @ @ 1Observe current carrying capacity!For this power supply variant, you will need the 750-626 Filter Module startingwith hardware version 4. This is the only filter module configured for the highercurrent carrying capacity. You can obtain the filter module from www.wago.com.Observe the isolation voltage!When using the 750-626 Filter Module, the isolation voltage of the field andelectronic power supply is reduced to 50 V against ground.Ensure the correct conductor cross-sectional area!Use conductor cross-sectionsranging from 0.08 mm² to 2.5 mm² (28 - 14 AWG)only for the CAGE-CLAMP® connections of the filter module.Requirements for connecting the supply voltage• You have connected two supply lines each to two voltage sources of+24 V DC and 0 V DC in a de-energized state.• You have connected the accompanying socket for the X4 connection to thesupply cable.Pos: 38.14 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1Table 22: Connection for Electronic Supply: Terminal LayoutX4 connector Pin Description1 V_IN (+)2 GND (-)1233 Shield (optional)
