WAGO-I/O-SYSTEM 750 Configuration 87758-874/000-131 WAGO-I/O-IPC-C6ManualVersion 1.0.09.1.16 Page „SNMP“On this page, change the parameters for the "Simple Network ManagementProtocol" on the SNMP configuration page. To accept your entries, click on the[SUBMIT] button or delete them by clicking on [DELETE].The "Community Name" must be transmitted in the SNMP package header. Thisassigns a type of access privilege. However, as this is transmitted in plaintext,SNMP in its first versions (v1 and v2c) is considered a very insecure protocol.IPC supports SNMP in versions v1, v2c, and v3.v2c offers a few additional functions in comparison with v1, and v3 introducedencryption and an improved authentication. In SNMP v3, exchanging messages isuser-related.Table 40: Description of the parameters for the "SNMP" pageGeneral SNMP ConfigurationGeneral SNMP information data are configured here.Name of device Device name (sysName)Description Device description (sysDescription)Physical location Device location (sysLocation)Contact Email contact address (sysContact)SNMP v1/v2c Manager ConfigurationProtocol enabled Activate/deactivate the SNMP protocol for v1/v2c here.Local Community NameYou specify here the community name for the SNMP managerconfiguration. The community name can be used to establishrelationships between SNMP managers and agents who arerespectively referred to as as community and who controlidentification and access between SNMP participants.The community name can be up to 32 characters long and maynot include spaces.To use the SNMP protocol, a valid community name mustalways be specified. The default community name is "public"SNMP v1/v2c Trap Receiver ConfigurationA list with the data for all configured "Trap Receivers" for v1/v2c is indicated here. The number ofReceivers is in principle not limited in the I/O-IPC. You have the opportunity to deleteindividually configured Receivers via [DELETE]. At the end of the list, you will find a form forcompiling a completely new Trap Receiver. Individual configuration data of already existingReceivers cannot be changed.IP Address IP address for the Trap Receiver (Management-Station)Community NameSpecify here the community name for the trap receiverconfiguration. The community name can be evaluated by the trapreceiver.The community name can be up to 32 characters long and maynot include spaces.Version SNMP version, via which the Traps are sent: v1 or v2c (Trapsvia v3 are configured in a different form).
