48 Installing and Removing the I/O-IPC WAGO-I/O-SYSTEM 750758-874/000-131 WAGO-I/O-IPC-C6ManualVersion 1.0.0Pos: 36.17 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x allgemein 1 @ 10\mod_1312439787258_21.doc @ 75849 @ 2 @ 16.6 Dismounting the I/O-IPCTo replace an I/O-IPC (e.g., in the event of version change), proceed as describedin the following section.Pos: 36.18 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x Heiße Oberseite PIKTOGRAMM @ 10\mod_1315199932690_21.doc @ 78103 @ @ 1CAUTIONHot surface!The I/O-IPC housing may become hot during operation. If the I/O-IPC has beenin operation, allow it to cool off before moving it.Pos: 36.19 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x Handlung allgemein @ 10\mod_1315199590906_21.doc @ 78100 @ 3 @ 16.6.1 Disconnecting Cables and ConductorsTo remove the cables and conductors, proceed as follows:1. Disconnect from the power supply those parts of the system on which youhave mounted the I/O-IPC.2. Disconnect the plugs/sockets from the I/O-IPC interfaces and remove thedata cables.3 Remove the conductors from the first 750 Series I/O Module connected tothe I/O-IPC (A).Pos: 36.20 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x FB - Bild 1 @ 10\mod_1312440870236_21.doc @ 75852 @ @ 1StopRunU1IDE/PWRIOERRSTARDYRUNU2…Figure 16: I/O-IPC interfacesPos: 36.21 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1A
