102 4 PaperChanging the Paper Type Settings of Trays 1 through 4If the paper type setting does not match the actual type of the paper, toner may not fuseproperly to the paper, resulting in poor print quality.Use the procedure below to change the paper type settings of trays 1 through 4.Important• If a paper type setting results in toner not fusing properly on the paper and poor print quality, try changingto a different paper type setting and printing again. If the paper type setting is for plain paper, forexample, try changing it to bond paper or recycled paper.Note• Refer to “Standard Paper and Tested Paper” (P. 92) for information about paper and control panelsettings.1. On the control panel, press the button to display the menu screen.2. Press the < > button until [Admin Menu] isdisplayed.3. Press the < > or button to select.[Network/Port] is displayed.4. Press the < > button until [PrinterSettings] is displayed.5. Press the < > or button to select.[Substitute Tray] is displayed.6. Press the < > button until [Paper Type] isdisplayed.7. Press the < > or button to select.[Tray 1] is displayed.8. Press the < > button until the desiredpaper tray is displayed, and then press the< > button to display its current setting.The current set value is displayed.9. Press the < > button until the desiredpaper type is displayed.(Example: Transparency)10. Press the button to apply the setting.MenuLanguageEmulationMenuAdmin MenuAdmin MenuNetwork/PortAdmin MenuPrinter SettingsPrinter SettingsSubstitute TrayPrinter Settingspaper TypePaper TypeTray 1Tray 1•PlainTray 1TransparencyTray 1•Transparency