58 3 Printing3.3 Printing on Custom Size or Long-sizePaperThis section explains how to print on long-size and custom size paper.The following are the sizes of paper that can be loaded into the paper trays.Loading Custom Size or Long Size PaperUsing the Bypass TrayThe following example explains how to load long-size paper into the bypass tray.Note• Finger prints can leave marks on the printing surface of long-size paper. Take care to avoid gettingmarks on the long size paper when loading it.• For information about loading other custom size paper, refer to “4.2 Loading Paper” (P. 95).• The only paper type setting that can be specified for long size paper is [Heavyweight (HW) (106 - 169 g/m2)].1. With the print side of the long-size paperfacing downwards, load the paper into thebypass tray with the trailing edge curled asshown in the illustration.Note• Curl the trailing edge of the long-size paper as far aspossible from the paper inlet slot. Curling it too closeto the paper inlet slot can result in the trailing edgefeeding into the printer, causing the paper to becreased or wrinkled.• Carefully insert the leading edge of the paper into theinlet slot of the bypass tray. Incorrect insertion cancause paper jams.• Load paper one sheet at a time.2. Adjust the paper guides to the size of thelong size paper.Since long-size paper is long, print onesheet at a time to ensure that the outputprint does not fall to the floor.Bypass Tray Trays 1 - 4Width:88.9 - 320 mmLength:98.4 - 1200 mmPaper feed directionWidth:139.7 - 297.0 mm *Length:182.0 - 431.8 mm*Paper feed direction* Tray 2 when the Single Tray Module is being usedLength: 182.0 - 457.2 mmWidth: 139.7 - 320.0 mmSide for printing
