8z A-band / B-band display areaA-band display modes: VFO mode: Memory mode (“M” and channel number): Home Channel: Repeater minus (-) shift: Repeater plus (+) shift: Split operationSpecified Memory Channel(Specify that only designated memory channels are scanned during memory scan-ning.)Skip Memory Channel(Permits designating undesired channels to be skipped during scanning.)Priority Memory Channel(The transceiver checks for signals on the frequency registered to the selected Priori-ty Memory Channel, once every 5 seconds.)ATT (attenuator) function(When the desired signal is extremely strong, activate the attenuator to reduce theincoming signal from the antenna.)Bell function is activated.TX/RX DG-ID is displayed:TXxx (The transmit DG-ID number), RXxx (The receive DG-ID number)Squelch type is displayed (For additional details, refer to the Advanced Manual.): Tone Encoder (tone frequency is displayed): Tone Squelch (tone frequency is displayed): DCS (Digital Code Squelch) (DCS code is displayed): Reverse Tone (tone frequency is displayed): Signal Squelch: Pager (EPCS)The following can be set when the squelch expansion (see page 73) is on.: Send the DCS code only during transmission.: Send the CTCSS tone signal during transmit, and wait for the DCS code in re-ceive mode. (tone frequency is displayed): Send the DCS code during transmit, and wait for the CTCSS tone signal in re-ceive mode. (tone frequency is displayed)
