77Set Mode: CONFIG Menu Operations1 Turn Power Off Automatically Auto Power-Off FunctionSet whether or not to turn the transceiver OFF automatically if there is no operation for acertain period of time.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Touch [1 APO].3. Rotate the DIAL knob to select the desired setting.OFF Does not turn the power OFF automatically.30 minutes to12 hoursTurns off the power when no operation is performed for a specifiedperiod of time.Remark The default setting: OFF• When the auto power-off function is active, [ appears on the LCD.• Once the time for automatic power-off is set, the new setting is retained. Unless “OFF” isselected in step 3, the next time the transceiver is turned on, if you perform no operationfor the set period of time, the transceiver will automatically turn OFF.)2 Preventing Accidental Transmission Busy Channel Lockout(BCLO) FunctionPreventing transmissions when the receive channel is busy.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Touch [2 BCLO].3. Rotate the DIAL knob to select the desired setting.OFF Permits starting a transmission while receiving a signal.ON Disables transmissions while receiving a signal.Remark The default setting: OFF3 Setting the Key Operation Confirmation SoundSet whether or not a beep sound is emitted to confirm when keys are operated, whenscanning reaches the end of a frequency band, or when a band edge/CH1 is encoun-tered.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Touch [3 BEEP].3. Rotate the DIAL knob to select [SELECT], then press the [DISP] key.4. Rotate the DIAL knob to select the desired setting referring to the table below.KEY & SCAN Emits the beep sound when a key is operated or scanning stops.KEY Emits the beep sound when a key is pressed.OFF Mutes the beep sound.Remark The default setting: KEY & SCAN5. Press the [BACK] key.6. Rotate the DIAL knob to select [EDGE], then press the [DISP] key.7. Rotate the DIAL knob to select the desired setting referring to the table below.