75Set Mode: SCAN Menu Operations1 Setting the Surveillance Interval Time for Priority ChannelsDW INTERVAL TIME FunctionWhen the dual receive function is active, the interval time at which the priority channel ismonitored can be set.1. Press and hold the [DISP] key, and then touch [SCAN].2. Rotate the DIAL knob, then touch [1 DW TIME].3. Rotate the DIAL knob to select the monitoring interval from 0.1 SEC to 10 SEC.Remark The default setting: 5.0 seconds2 Setting the Illumination On/Off When Scanning StopsLAMP FunctionSet whether or not the LCD backlight is turned on when a signal is received during scan-ning.1. Press and hold the [DISP] key, and then touch [SCAN].2. Rotate the DIAL knob, then touch [2 SCAN LAMP].3. Rotate the DIAL knob to select the desired setting.ON The LCD backlight will illuminate when a signal is received.OFF The LCD backlight will not illuminate when a signal is received.Remark The default setting: ON3 Setting the Time to Resume Scanning SCAN RE-START FunctionSet the time interval to resuming scanning after a received signal ends during scanning.1. Press and hold the [DISP] key, and then touch [SCAN].2. Rotate the DIAL knob, then touch [3 SCAN RE-START].3. Rotate the DIAL knob to select the time to resume scanning from 0.1 SEC to 10 SEC.Remark The default setting: 2.0 seconds4 Selecting a Receive Operation When Scanning StopsTouch [4 SCAN RESUME] to set the receive operation for when scanning stops.For details, see “Setting the Receive Operation When Scanning Stops” on page 37.5 Setting the Scanning RangeYou can set the frequency range for scanning in VFO mode and Memory mode.1. Press and hold the [DISP] key, and then touch [SCAN].2. Touch [5 SCAN WIDTH].3. Rotate the DIAL knob to select [VFO], then press the [DISP] key.4. Rotate the DIAL knob to select the desired setting referring to the table below.ALL Scans all bands from the current frequency within the 1.8 MHz to 999MHz range.BAND Starting with the current frequency, scans within the current band.5. Press the [BACK] key.6. Rotate the DIAL knob to select [MEMORY], then press the [DISP] key.
