8216 Setting the frequency offset for Repeater ShiftRPT SHIFT FREQ FunctionSet the repeater shift offset frequency.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Rotate the DIAL, then touch [16 RPT SHIFT FREQ].3. Rotate the DIAL knob to select the desired shift offset.4. The offset frequency can be set in steps of 0.05 MHz between 0.000 MHz and150.000 MHz.Remark The default setting differs depending frequency17 Disabling Receiver While No Signal Is ReceivedReceiver Battery Save FunctionSets the Receive OFF Battery save interval (sleep ratio) to reduce power consumption.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Rotate the DIAL, then touch [17 SAVE RX].3. Rotate the DIAL knob to select the desired setting (the time interval for disabling thereceiver operation).0.2 sec (1:1) to 1.0 sec (1:5) In steps of 0.1 secondto 1.0 sec (1:5) to 10 sec (1:50) In steps of 0.5 secondto 1.0 sec (1:50) to 60 sec (1:300 sec) In steps of 5 secondOFF Disables the Battery save function.4. Selecting OFF disables this function.Remark The default setting: 0.2 sec (1:1)18 Changing the Frequency Step ManuallyRotate the DIAL knob to select [18 STEP] to set each frequency step, when the DialKnob is turned manually.For additional details, refer to the Advanced Manual which may be downloaded from theYaesu website.19 Setting Clock TimeSet the date and time function of the built-in clock of the FT3DR/DE.In the factory settings, the date and time are automatically set when positioning the GPSsignal, so in this case no manual setting is necessary.1. Press and hold the [DISP] key, and then touch [CONFIG].2. Rotate the DIAL, then touch [19 DATE & TIME ADJ].3. Rotate the DIAL knob to select the year, month, day, hour and minute.4. To activate the time signal (alarm goes off every hour on the hour), touch [SIGNAL].The checkbox will be checked.5. Touch [OK].