Yamaha FZ09E Service Manual

••••••••••••••••••••••••••••••••5. Install:• Upper bracketRefer to "HANDLEBAR" on page 4-44.EAS1RC l 32 1LUBRICATING THE STEERING HEAD1. Lubricate:• Upper bearing• Lower bearing• Bearing raceslEA$1A C1322Recommended lubrican tLithium -soap-based greaseCHECKING THE CHASSIS FASTENERSMake sure that all nuts, bolts, and screws areproperly tightened.Refer to "CHASSIS TIGHTENING TORQUES"on page 2 -1 8.EAS1RC I XGLUBRICATING THE BRAKE LEVERLub ricate the pivoting point and metal-to-metalmoving parts of the lever.Recommended lubrican t1-mtl Silicone greaseEAS1A C1XMLUBRICATING THE CLUTCH LEVERLubricate the pivoting po in t and metal-to-metalmov in g parts of the lever.l Recommended lubrlcantLithium-soap-based greaseLUBRICATING THE PEDALLubricate the pivoting po in t and metal-to -m etalmov in g parts of the peda l.l Reco mme nd ed lubricantLith i um -soap-based greasePERIODIC MAINTENANCE.....,,..ADJUSTING THE SHIFT PEDALTI P ~~~~~~~~~~~~~~~The shift pedal position is determined by the in-stalled shift rod length.1. Measure:• Insta ll ed shift rod length "a"Incorrect~ Adjust.2. Adjust:Installed shift rod length256.9-258.9 mm (10.11-10.19 in)• Insta ll ed shift rod length••••••••••••••••••••••••••••••••a. Loosen both locknuts "1 ".b. Tu rn the s hi ft rod "2" in direction "a" or "b" toobtain the correct shift pedal position.Direction "a"Installed s hift rod length increases.Direction " b"Installed shift rod length decreases.c. Tighten both locknuts.d. Make sure the installed shift rod length iswithin specificati on.EAS 1 AC1~CHECKING THE SIDESTAND1. Check:• Sidestand operationCheck that the sidestand moves smoothly.3-19