Yamaha FZ09E Service Manual

GENERATOR AND STARTER CLUTCHerator rotor "2" and hold the generator rotor.b. When tu rni ng the starter clutch gear clock-wise "fl(', the starter clutch and the starterclutch gear should engage, otherwise thestarter clutch is faulty and must be replaced.c. When turning the starter clutch gear counter-clockwise "B'', it should tu rn freely, otherwisethe starter clutch is faulty and must be re-placed.A1 1\ B 2''"'''""INSTALLING THE STARTER CLUTCH1 . Install:• Starter clutch "1"Starter clutch bolt32 Nm (3.2 m·kgf, 23 ft·lbf)LOCTITE®TIP ~~~~~~~~~~~~~~• Install the starter clutch so that the side of thestarter clutch roller assembly with the arrowmark "a" is towa rd the generator rotor "2".• While holding the generator rotor with thesheave holder "3", tighten the starter clutchbolts.Sheave holder90890-01701Primary cl utch holderYS-01880-A......500INSTALLING THE GENERATOR1. Insta ll :• Woodruff key• Generator rotor• Washer lf@ii• Generator rotor boltTIP ~~~~~~~~~~~~~~~• Clean the tapered portion of the crankshaft andthe generator rotor hub.• When installing the generator rotor, make surethe woodruff key is properly seated in the key-way of the crankshaft.• Lubricate the washer with engine oil.• Lubricate the generator rotor bolt threads andwasher mating surfaces with engine oil.2. Tighten:• Generator rotor bolt "1"Generator rotor bolt75 Nm (7.5 m·kgf, 54 ft·lbf)TIP ~~~~~~~~~~~~~~While holding the generator rotor "2" with thesheave holder "3", tighten the generator rotorbolt.5-33Sheave holder90890-01701Primary clutch holderYS-01880-A