Chapter 5: Local Management5-546H128-08 and 6H129-08 User’s Guide4. If you ENABLED the port, proceed to Section 5.15.11.1, Changingthe Com Port Application. If you DISABLED the port, use the arrowkeys to highlight SAVE at the bottom of the screen, then pressENTER.When the message “SAVED OK” displays, the edits aresaved.5.15.11.1 Changing the Com Port ApplicationAfter enabling the COM port as described in Section 5.15.11, you canselect one of the applications supported by the COM port: LM, and UPS.The default application is LM.To change the COM port application:1. Use the arrows keys to highlight the Application field.2. Use the SPACE bar or BACKSPACE to step through the availablesettings until the operation you require appears. Table 5-3 lists theavailable settings and their corresponding applications.3. Press ENTER to accept the application.4. Use the arrow keys to highlight SAVE at the bottom of the screen, thenpress the ENTER key.!CAUTIONExiting without saving causes the message “NOT SAVED --PRESS SAVE TO KEEP CHANGES” to appear. Exiting withoutsaving causes all edits to be lost.!CAUTIONWhen the COM port is configured to perform the UPSapplication, all future Local Management connections must bemade by establishing a Telnet connection to the module.Ensure that the module has a valid IP address before savingchanges to the COM port application. If the module does nothave a valid IP address and the changes are saved, refer toAppendix C for instructions on clearing NVRAM in order toreestablish COM port communications.Table 5-3 COM Port Application SettingsSetting ApplicationLM Local Management SessionUPS APC Power Supply SNMP Proxy
