Chapter 5: Local Management5-746H128-08 and 6H129-08 User’s GuidePeak Switch Utilization (Read-only)Shows the peak percentage of maximum switching capacity, since lastreset.Reset Peak Switch Utilization (Toggle)Allows the user to reset the Peak Switch Utilization field. The switch maybe set to either YES or NO as described in Section 5.21.1. YES resets thePeak Switch Utilization field to the current system traffic.5.21.1 Setting the Reset Peak UtilizationTo set the Reset Peak Utilization field to YES or NO, proceed as follows:1. Use the arrow keys to highlight the Reset Peak Switch Utilizationfield.2. Press the SPACE bar to select YES or NO.3. Use the arrows keys to highlight the SAVE command at the bottom ofthe screen.4. Press ENTER. The message “SAVED OK” is displayed.5.22 FLASH DOWNLOAD SCREENThe Flash Download screen, shown in Figure 5-28, allows the user toclear the information stored in the 6H12X-08 FLASH memory anddownload a new image file from a TFTP server.Before downloading a new image to the module, load the image onto thenetwork TFTP server.NOTEThe user may also force a download by changing the positionof Switch 6 located inside the module. Refer to Section C.2 fordetails.NOTEFor information on how to set up a workstation as a TFTPserver, refer to the specific workstation documentation.
