Chapter 5: Local Management5-506H128-08 and 6H129-08 User’s Guide5.15.8 Setting the Screen Lockout TimeThe screen lockout time can be set from 1 to 30 minutes with a default of15 minutes. To set a new lockout time, perform the following steps:1. Use the arrow keys to highlight the Screen Lockout Time field.2. Enter a number from 1 to 30.3. Press ENTER to set the lockout time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is within the 1 to 30 minutes range, the Event MessageLine at the top of the screen displays “SAVED OK”. If the entry is notvalid, Local Management does not alter the current setting, but it doesrefresh the Screen Lockout Time field with the previous value.5.15.9 Setting the Operational ModeTo set the Operational Mode, proceed as follows:1. Use the arrow keys to highlight the Operational Mode field.!CAUTIONBefore setting the operational mode, ensure that the itemscontained in this caution are fully understood.If the module will be configured to operate as a SecureFastswitch, the following procedures should be performed beforesetting the operational mode:The module must be assigned a unique IP address.The Management Mode of the module must be set toSTAND ALONE. The Management Mode field will no longerdisplay on the General Configuration screen, and the modulewill no longer support Chassis Configuration and ModuleSelection screens. If the module will be a SecureFast switch,distributed management is not allowed.The module has been assigned SNMP community names fromthe module SNMP Community Names screen (Section 5.16).In Standalone management mode, the module does not usethe community names of the 6C105 chassis.
