Port Redirect Function Screen6H128-08 and 6H129-08 User’s Guide5-31Chassis Fan Status (Read-Only)Displays the current status of the 6C105 fan tray. This field displays either“Normal”, “Fault”, or “Not Installed”.5.11 PORT REDIRECT FUNCTION SCREENThe Port Redirect Function screen, Figure 5-14, allows the user to seteach one of the modules in the chassis (1 through 5), and the ports of thecorresponding module, as a source or destination port. A port can be set tohave one or more destination ports and chassis module slot numbers. Forexample, port 1 in module (slot) 1 can be set as a source port with threedestinations, ports 2, 3, and 4 in module (slot) 3. Traffic from port 1 inmodule 1 is then automatically redirected to ports 2, 3, and 4 in module 3.Port 1 in module 1 can also serve as a destination port for other ports andmodules. The port redirect function is extremely useful fortroubleshooting purposes, as it allows traffic to be sent to a particularport(s) where, with the use of an analyzer or RMON probe, all currenttraffic from the source port(s) can be examined.NOTEThe Port Redirect Function screen may not be availabledepending on the operational mode that has been set for thechassis. Refer to the Release Notes to see what operationalmodes support the Port Redirect Function. Refer toSection 5.7.7 for instructions on configuring the operationalmodes of all the modules installed in the chassis.NOTEThe module number corresponds to the slot number in whichthe module resides in the 6C105 chassis (1 through 5).NOTEAlthough traffic from the source port (including, if desired,errored frames) is sent to the destination port, normal switchingis still performed for all frames on the source port.
