Chapter 5: Local Management5-606H128-08 and 6H129-08 User’s Guide5.17 SNMP TRAPS SCREENSince the 6H12X-08 is an SNMP compliant device, it can send messagesto multiple Network Management Stations to alert users of statuschanges. The SNMP Traps screen is shown in Figure 5-23.Access the SNMP Traps screen from the Module Configuration Menuscreen by using the arrow keys to highlight the SNMP TRAPS menu itemand pressing ENTER. The SNMP Traps screen displays.Figure 5-23 SNMP Traps ScreenThe following explains each field of the SNMP Traps screen.Trap Destination (Modifiable)Indicates the IP address of the workstation to receive trap alarms. Up toeight different destinations can be defined.NOTEIt is only necessary to assign SNMP traps if the user desiresthe traps to be sent to different addresses than those assignedin Section 5.9, which details how to set SNMP Traps for the6C105 chassis.Firmware Revision: XX.XX.XXSNMP Traps2159-18BOOTPROM Revision: XX.XX.XXTrap Community NamepublicpublicpublicpublicpublicpublicpublicModule Type: 6H128-08Slot Number:XEXIT6H128-08 LOCAL MANAGEMENTEvent Message LineRETURNSAVETrap Destination0.0.0.00.0.0.00.0.0.00.0.0.00.0.0.00.0.0.00.0.0.0Enable Traps[NO][NO][NO][NO][NO][NO][NO]
