General Configuration Screen6H128-08 and 6H129-08 User’s Guide5-493. Press ENTER to set the module time to the time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is a valid format, the Event Message Line at the top ofthe screen displays “SAVED OK”. If the entry is not valid, LocalManagement does not alter the current value and refreshes the ModuleTime field with the previous value.5.15.7 Entering a New Screen Refresh TimeThe screen refresh time is set from 3 to 99 seconds with a default of 3seconds. To set a new screen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the inputfield.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is within the 3 to 99 seconds range, the Event MessageLine at the top of the screen displays “SAVED OK”. If the entry is notvalid, Local Management does not alter the current setting, but it doesrefresh the Screen Refresh Time field with the previous value.NOTEWhen entering the time in the Module Time field, separatorsbetween hours, minutes, and seconds do not need to be addedas long as each entry uses two numeric characters. Forexample, to set the time to 6:45 A.M., type “064500” in theModule Time field.
