7-10 Sending Faxes Chapter 7Redialing When the Line is BusyThere are two methods of redialing: Manual redialing and Automatic redialing. Thissection explains these two methods.Manual RedialingPress Redial/Pause to dial the last number you dialed with the numeric buttons. (Thisstarts redialing regardless of whether automatic redialing is enabled.)Canceling Manual RedialingTo cancel manual redialing, press Stop.Automatic RedialingWhat is Automatic Redialing?When you are sending using memory sending and the other party’s line is busy, theunit waits the specified time and then dials the same number again. You can set thecopier/fax to redial several times if previous attempts fail because of a busy signal. Thisfeature is called Automatic redialing.After the initial dial attempt, the copier/fax is factory-set to wait two minutes and then tryto dial again. If the second attempt fails because the line was busy, the copier/fax willagain wait for two minutes and make a final attempt to complete the call.*Automatic redialing can be turned off and on. The number of redialing attempts and thetime interval between attempts can also be adjusted. (1 p. 7-11)If all redialing attempts are unsuccessful, the copier/fax will cancel the transmission andprint an Error TX Report to remind you that the transmission was not completed. (1 p.11-4)When automatic redialing is in use, the LCD alternately displays AUTO REDIAL and thetransaction number (TX/RX NO.) while it is waiting to redial.Canceling Automatic RedialingAutomatic redialing cannot be canceled with the Stop button while the unit is waiting toredial.Follow this procedure to cancel automatic redialing:1 Wait until the copier/fax begins redialing. DIALING* Even if the copier/fax is set to redial several times, it will redial only once if there is no tone or there is aring back tone during the first attempt.
