4 Close the shield, and then the access door.1 2Installing a memory cardCAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware ormemory devices sometime after setting up the printer, then turn the printer off, and unplug the power cordfrom the electrical outlet before continuing. If you have any other devices attached to the printer, then turnthem off as well, and unplug any cables going into the printer.Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.Touch something metal on the printer before touching any controller board electronic components or connectors.Note: An optional memory card can be purchased separately and attached to the controller board.1 Access the controller board.For more information, see “Accessing the controller board” on page 28.2 Unpack the memory card.Warning—Potential Damage: Do not touch the connection points along the edge of the card. Doing so maycause damage.3 Align the notch (1) on the memory card with the ridge (2) on the connector.12Additional printer setup 30
