Installing a printer hard diskCAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware ormemory devices sometime after setting up the printer, then turn the printer off, and unplug the power cordfrom the electrical outlet before continuing. If you have any other devices attached to the printer, then turnthem off as well, and unplug any cables going into the printer.Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.Touch something metal on the printer before touching any controller board electronic components or connectors.1 Unpack the printer hard disk.2 Install the printer hard disk on the controller board.Warning—Potential Damage: Hold only the edges of the printed circuit board assembly. Do not touch or presson the center of the printer hard disk. Doing so may cause damage.a Using a flathead screwdriver, loosen the screws.b Insert the plug of the printer hard disk interface cable into the receptacle of the controller board.Note: The plug and the receptacle are color‑coded blue.Additional printer setup 40
