CHAPTER 8 - PXG200E CONFIGURATION WEB PAGEEATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:383594Manually Enter IPv4 Address4. If your network uses a static IP address:NOTICE: The data in these fields must be entered using thecorrect format or an error message will appear.a. Uncheck the “Automatically Obtain IP Address” box (Figure 93, A).b. Enter the Static IP Address (Figure 93, B).NOTICE: Changing the static IP address will disconnect yourbrowser if you are configuring through the Ethernet LANport on the PXG200E.c. Enter the Netmask (Figure 93, C).d. Enter the Gateway (Figure 93, D).e. If you will be using one or more Domain Name Servers, type the IPaddress of each Domain Name Server in the corresponding NameServer box (Figure 93, E). Up to three IP addresses can be entered.NOTICE: When you enter the configuration for anyApplication Server (such as Access Control) you will beasked for the address of the host or server. If you enter thename of the server instead of the IP address you MUST enterthe IP address of at least one Domain Name Server in aName Server box (Figure 93, E).Figure 935. You can SAVE ALL SETTINGS, VIEW CHANGES or DISCARD CHANGESthat you have made. For details on how to use these functions, seeCommon PXG200E Configuration Functions on page 35.PXG200E_263AB CDE
