CHAPTER 7 - ACCESSING THE PXG200E27EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Chapter 7 Accessing the PXG200EUsing a USB ConnectionIt is recommended that you use the USB connection only for initial deviceconfiguration and validation of the PXG200E.Use this procedure to connect the PXG200E USB port to a USB port on yourWindows computer and login.Note that you can also login to the PXG200E by using the Ethernet LAN porton the PXG200E. Refer to Using an Ethernet LAN Connection onpage 29 for details.RequirementsTo configure the PXG200E using the USB port you must have:• A 32 or 64 bit, PC-compatible, computer• A USB AB cable• USB driver files (contained on the PXG200E CD-ROM that came with theunit)Procedure1. Connect one end of a USB AB cable to the PXG200E USB port(Figure 14, A) and the other end to an available USB port on yourcomputer.Figure 142. If you get the “Found New Hardware” dialog box shown in Figure 15,youmust install the PXG200E USB drivers using the procedure in USBDriver Installation on page 155.Figure 153. After you connect both ends of the USB AB cable, and the USB driver isinstalled, wait at least two minutes for the PXG200E to be properlyrecognized by your computer.COM 1INCOMCOM 1INCOMRESTARTSHLDD2D1CMNA (-)B (+)+ VGND1 2PXG 200E24 VDCPXG200E_013AUPSTREAM DOWNSTREAMPXG200E_014
