CHAPTER 2 - TECHNICAL DATAEATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:38356PXG200E Kit ContentsEach PXG200E kit contains the following components:• PXG200E• Standard Panel Mounting Hardware• DIN Rail Adapter• PXG200E CD-ROMPXG200E CD-ROM ContentsPXG200E CD-ROM contains the following items:• USB driver• Supported Device List• Supported Device Data Maps (i.e., Modbus TCP Register Maps)• PDF copy ofEaton Electrical Field Devices Communication WiringSpecification (TD 17513)• PDF copy ofPXG200E User ManualRequirements for PXG200E InstallationWhen you install a PXG200E you should have the following items available:• USB AB cable•Either of the following• CAT 5 STP*/UTP. *Based on the applications, STP may be necessaryfor electromagnetic immunity requirements. A CAT 5 Ethernet LANcable is for connecting the PXG200E Ethernet LAN port to theEthernet LAN system, such as to a router or switch.• An Ethernet LAN Crossover cable. An Ethernet LAN Crossover cableis for connecting the PXG200E Ethernet LAN port directly to theEthernet LAN port on your computer without connecting to thenetwork.• Cable for communications between the Modbus RTU and INCOMdevices and the PXG200E communications ports.• 24 VDC Power Supply• Input Voltage, Nominal: 24 VDC; 0.8 A• Input Voltage Range: +/- 20% NominalNOTICE: The recommended power supply part number ELC-PS02 is available and meets these requirements.• #1 Phillips Screwdriver - Required for the smaller Phillips screws in theDIN rail adapter mounting hardware kit.• #2 Phillips Screwdriver - Required for the larger Phillips screws in theDIN rail adapter mounting hardware kit.• 0.5 x 3 mm (0.02 x 0.12 in) (thickness x width) Flathead Screwdriver -Required for the wiring connectors.
