CHAPTER 1 - SAFETY PRECAUTIONS1EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Chapter 1 Safety PrecautionsAll safety codes, safety standards and / or regulations must be strictlyobserved in the installation, operation and maintenance of this device.W A R N I N GIndicates a hazardous situation, which, if not avoided, could result in death or serious injury.C A U T I O NIndicates a hazardous situation, which, if not avoided, could result in minor or moderateinjury.NOTICE Indicates a situation which can cause damage to the unit, personal propertyand / or the environment or cause the equipment to operate improperly.W A R N I N GThe safety message that follows has WARNING level hazards.SHOCK HAZARDS!IMPROPER INSTALLATION CAN CAUSE DEATH, INJURY AND / OR EQUIPMENT DAMAGE.Follow all Warnings and Cautions. Completely read and understand the information in thisdocument before attempting to install or operate the equipment. Improper wiring couldcause death, injury and / or equipment damage. Only qualified personnel are to service anyPower Xpert device.TROUBLESHOOTING PROCEDURES MAY REQUIRE PROXIMITY TO EXPOSED ENERGIZED(LIVE) ELECTRICAL WIRING AND / OR PARTS WHERE THE HAZARD OF FATAL ELECTRICSHOCK IS PRESENT.Exercise extreme care to avoid injury or death. Always disconnect, lock-out and tag thecurrent and voltage sources and the control power supply circuit before touching theconnections or components on the front face of the unit.FAILURE TO GROUND THE PXG200E MAY RESULT IN INJURY, DEATH OR EQUIPMENTDAMAGE.Properly ground the PXG200E during installation.
