CHAPTER 8 - PXG200E CONFIGURATION WEB PAGE113EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Time SettingsTime Settings allows you to synchronize the PXG200E with the NetworkTime Protocol (NTP) servers, or you can manually enter the time and date. Ifyou choose to use the NTP, you may use the default NTP addresses or enteran IP address or host name of the NTP server(s) you would like to use. Thedefault NTP servers may not be accessible due to your corporate IT securityfirewall settings. Therefore, you may choose to enter your own settings. It isrecommended that you do this prior to adding devices to the device list. Thiswill ensure that the data reported to Power Xpert Software is correctly time-stamped.1. Click on the DATE/TIME link (Figure 118, A) in the toolbar of thePXG200E configuration web page.Figure 1182. If you leave the “Synchronize with NTP server(s)” box (Figure 118, B)checked, you can designate the NTP server(s) that you want to use.3. If you leave the “Synchronize with NTP server(s)” box (Figure 118, B)checked, the current “NTP Status” is shown (Figure 118, C). Sometypical status statements are:Not RunningTesting for valid NTP serversStarted, not synchronizedSynchronizing with NTP serverSynchronized to aaa.bb.cc, NTP stratum 1 (where “aaa.bb.cc” is theaddress of the NTP server)PXG200E_113AEFGDB CH
