GE 469 Instruction Manual

Also see for Masoneilan 469 Series: Instruction manual Instruction manual Instruction manual Communications guide Instruction manual

Contents

Diagnostics 469Motor Management RelayActual Valueshttp://www.GEindustrial.com/multilin 6–31GE MultilinFlash Messages Flash messages are warning, error, or general information messages that aretemporarily displayed in response to certain key presses. These messages areintended to assist with navigation of the 469 messages by explaining what hashappened or by prompting the user to perform certain actions.• [.] KEY IS USED TO ADVANCE THE CURSOR: Any time a setpoint thatrequires text editing is viewed, this message will appear immediately to promptthe user to use the decimal key for cursor control. If the setpoint is not alteredfor one (1) minute, the message will flash again.• ACCESS DENIED, ENTER PASSCODE: The 469 has a passcode securityfeature. If that feature has been enabled, not only do the access switchterminals have to be shorted, but the passcode must also be entered. If thecorrect passcode has been lost or forgotten, contact the factory with theencrypted access code. See Passcode on page 5–7 for passcode features.• ACCESS DENIED, SHORT ACCESS SWITCH: In order to store any setpointvalues, the access switch must be shorted. If this message appears and it isnecessary to change a setpoint, short access terminals C1 and C2.• ALL POSSIBLE RESETS HAVE BEEN PERFORMED: If only some of the tripand alarm features that are active can be cleared (i.e. the conditions thatcaused some of these trips and/or alarms are still present), then this messagewill appear when a RESET is performed, indicating that only trips and alarmsthat could be reset have been reset.• ARE YOU SURE? PRESS [ENTER] TO VERIFY: If the RESET key is pressed andresetting of any trip or alarm feature is possible, this message will appear to askfor verification of the operation. If RESET is pressed again while the message isstill on the display, the reset will be performed.• DATA CLEARED SUCCESSFULLY: This message confirms that data has beencleared or reset in the S1 469 SETUP ZV CLEAR DATA or S1 469 SETUP ZVINSTALLATION setpoint groups.• DATE ENTRY WAS NOT COMPLETE: Since the DATE setpoint has a specialformat (MM/DD/YYYY), if ENTER is pressed before the complete value is entered,this message appears and the new value is not stored. Another attempt willhave to be made with the complete information.• DATE ENTRY WAS OUT OF RANGE: This message appears if and invalid entryis made for the DATE (e.g. 15 entered for month).[.] KEY IS USED TOADVANCE THE CURSORACCESS DENIED,ENTER PASSCODEACCESS DENIED,SHORT ACCESS SWITCHALL POSSIBLE RESETSHAVE BEEN PERFORMEDARE YOU SURE? PRESS[ENTER] TO VERIFYDATA CLEAREDSUCCESSFULLYDATE ENTRYOUT OF RANGEDATE ENTRY WASNOT COMPLETEDEFAULT MESSAGEHAS BEEN ADDEDDEFAULT MESSAGEHAS BEEN REMOVEDDEFAULT MESSAGELIST IS FULLDEFAULT MESSAGES6 TO 20 ARE ASSIGNEDEND OF LIST END OF PAGE ENTER NEW PASSCODEFOR ACCESSINPUT FUNCTIONALREADY ASSIGNEDINVALID PASSCODEENTERED!INVALID SERVICECODE ENTEREDKEY PRESSED ISINVALID HERENEW PASSCODEHAS BEEN ACCEPTEDNEW SETPOINT HASBEEN STOREDNO ALARMS NO START BLOCKSACTIVENO TRIPS OR ALARMSTO RESETOUT OF RANGE! ENTER:####-##### by #PRESS [ENTER] TO ADDDEFAULT MESSAGEPRESS [ENTER] TOREMOVE MESSAGERESET PERFORMEDSUCCESSFULLYROUNDED SETPOINTHAS BEEN STOREDSETPOINT ACCESS ISNOW PERMITTEDSETPOINT ACCESS ISNOW RESTRICTEDTHIS FEATURE NOTPROGRAMMEDTIME ENTRYOUT OF RANGETIME ENTRY WASNOT COMPLETETOP OF LIST TOP OF PAGE