Working with Setpoints and Setpoint Files 469Motor Management RelayInterfaceshttp://www.GEindustrial.com/multilin 4–21GE Multilin3. The Print/Export Options dialog box will appear. Select Actual Values in theupper section and select either Include All Features (for a complete list) orInclude Only Enabled Features (for a list of only those features which arecurrently used) in the filtering section and click OK.Actual values lists can be printed in the same manner by right clicking on thedesired device (in the device list) and selecting the Print Device Informationoption.g) Loading Setpoints from a FileAn error message will occur when attempting to download a setpoint filewith a revision number that does not match the relay firmware. If thefirmware has been upgraded since saving the setpoint file, see UpgradingSetpoint Files to a New Revision on page 4–19 for instructions on changing therevision number of a setpoint file.The following procedure illustrates how to load setpoints from a file. Before loadinga setpoints file, it must first be added to the EnerVista 469 Setup environment asdescribed in Adding Setpoints Files to the Environment on page 4–18.1. Select the previously saved setpoints file from the File pane of the EnerVista469 Setup software main window.2. Select the File > Properties menu item and verify that the corresponding fileis fully compatible with the hardware and firmware version of the target relay. Ifthe versions are not identical, see Upgrading Setpoint Files to a New Revision onpage 4–19 for details on changing the setpoints file version.3. Right-click on the selected file and select the Write Settings to Device item.4. The EnerVista 469 Setup software will generate the following warning message,to remind the user to remove the relay from service, before attempting to loadsetpoints into an in-service relay.:5. Select the target relay from the list of devices shown and click Send. If there isan incompatibility, an error of the following type will occur.6. If there are no incompatibilities between the target device and the Setpointsfile, the data will be transferred to the relay. An indication of the percentagecompleted will be shown in the bottom of the main menu.WARNING
