Operation Manual – SSHH3C S7500E Series Ethernet Switches Chapter 1 SSH Configuration1-61.2.2 Enabling SSH ServerFollow these steps to enable SSH server:To do… Use the command… RemarksEnter system view system-view —Enable the SSH serverfunction ssh server enable RequiredDisabled by default1.2.3 Configuring the User Interfaces for SSH ClientsAn SSH client accesses the device through a VTY user interface. Therefore, you needto configure the user interfaces for SSH clients to allow SSH login. Note that theconfiguration takes effect at the next login.Follow these steps to configure the protocols for the current user interface to support:To do… Use the command… RemarksEnter system view system-view —Enter user interface viewof one or more userinterfacesuser-interface vtynumber [ ending-number ] RequiredSet the loginauthentication method toschemeauthentication-modescheme[ command-authorization ]RequiredBy default, theauthentication mode ispassword.Specify the protocols forthe user interfaces tosupportprotocol inbound { all |ssh | telnet }OptionalAll protocols aresupported by default.Caution:z For detailed information about the authentication-mode and protocol inboundcommands, refer to Login Commands.z If you configure a user interface to support SSH, be sure to configure thecorresponding authentication method with the authentication-mode schemecommand.z For a user interface configured to support SSH, you cannot configure theauthentication-mode password command and the authentication-mode nonecommand.
