Operation Manual – IPv6 RoutingH3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration5-6To do... Use the command... RemarksAllow the establishment ofEBGP connection to anon directly connectedpeer/peer grouppeer { ipv6-group-name |ipv6-address }ebgp-max-hop[ hop-count ]RequiredNot configured by defaultCaution:In general, direct links should be available between EBGP peers. If not, you can usethe peer ebgp-max-hop command to establish a multi-hop TCP connection inbetween. However, you need not use this command for direct EBGP connection withloopback interfaces.5.3.7 Configuring a Description for a Peer/Peer GroupFollow these steps to configure description for a peer/peer group:To do... Use the command... RemarksEnter system view system-view —Enter BGP view bgp as-number RequiredEnter IPv6 address familyview ipv6-family —Configure a descriptionfor a peer/peer grouppeer { ipv6-group-name |ipv6-address }descriptiondescription-textOptionalNot configured by defaultNote:The peer group to be configured with a description must have been created.5.3.8 Disabling Session Establishment to a Peer/Peer GroupFollow these steps to disable session establishment to a peer/peer group:To do... Use the command... RemarksEnter system view system-view —Enter BGP view bgp as-number Required
