Operation Manual – IPv4 RoutingH3C S7500E Series Ethernet Switches Chapter 1 Static Routing Configuration1-3To do… Use the command… RemarksEnter system view system-view —Configure a staticrouteip route-static dest-address{ mask | mask-length }{ gateway-address | interface-typeinterface-number[ gateway-address ] } [ preferencepreference-value ] [ tag tag-value ][ description description-text ]RequiredBy default,preference for staticroutes is 60, tag is 0,and no descriptioninformation isconfigured.Configure the defaultpreference for staticroutesip route-staticdefault-preferencedefault-preference-valueOptional60 by defaultNote:z When configuring a static route, the static route does not take effect if you specifythe next hop address first and then configure it as the IP address of a local interface,such as a VLAN interface.z If you do not specify the preference when configuring a static route, the defaultpreference will be used. Reconfiguring the default preference applies only to newlycreated static routes.z You can flexibly control static routes by configuring tag values and using the tagvalues in the routing policy.z If the destination IP address and mask are both configured as 0.0.0.0 with the iproute-static command, the route is the default route.1.3 Displaying and Maintaining Static RoutesTo do… Use the command… RemarksDisplay the current configurationinformation display current-configurationDisplay the brief information ofthe IP routing table display ip routing-tableDisplay the detailed informationof the IP routing tabledisplay ip routing-tableverboseView information of static routesdisplay ip routing-tableprotocol static [ inactive |verbose ]Available inany viewDelete all the static routes delete static-routes all Available Insystem view
