Operation Manual – IPv6 RoutingH3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration5-20II. Apply a routing policy to routes advertised to a peer/peer groupFollow these steps to apply a routing policy to routes advertised to a peer/peer group:To do... Use the command... RemarksEnter system view system-view —Enter BGP view bgp as-number RequiredEnter IPv6 address familyview ipv6-family —Apply a routing policy toroutes advertised to apeer/peer grouppeer { ipv6-group-name |ipv6-address } route-policyroute-policy-name exportRequiredNot applied by defaultNote:When configuring IPv6 BGP community, you need to configure a routing policy todefine the community attribute, and apply the routing policy to route advertisement.5.7.4 Configuring an IPv6 BGP Route ReflectorFollow these steps to configure an IPv6 BGP route reflector:To do... Use the command... RemarksEnter system view system-view —Enter BGP view bgp as-number RequiredEnter IPv6 address familyview ipv6-family —Configure the router as aroute reflector and specifya peer/peer group as aclientpeer { ipv6-group-name |ipv6-address }reflect-clientRequiredNot configured by defaultEnable route reflectionbetween clients reflect between-clients OptionalEnabled by defaultConfigure the cluster IDof the route reflectorreflector cluster-idcluster-idOptionalBy default, a routereflector uses its router IDas the cluster ID
