Operation Manual – IPv6 ConfigurationH3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration1-24To do… Use the command… RemarksClear IPv6 dynamic domainname cache information reset dns ipv6 dynamic-hostAvailablein userviewClear IPv6 neighborinformationreset ipv6 neighbors { all | dynamic| interface interface-typeinterface-number | slot slot-number |static }Clear the correspondingPMTUreset ipv6 pathmtu { all | static |dynamic}Clear the statistics of IPv6and ICMPv6 packetsreset ipv6 statistics [ slotslot-number ]Clear all IPv6 TCPconnection statistics reset tcp ipv6 statisticsClear the statistics of all IPv6UDP packets reset udp ipv6 statisticsAvailablein userviewNote:The display dns domain command is the same as the one of IPv4 DNS. For detailsabout the commands, refer to DNS Commands.1.10 IPv6 Configuration ExampleI. Network requirementsTwo switches are directly connected through two Ethernet ports. The Ethernet portsbelong to VLAN 2. Configure different types of IPv6 addresses for VLAN-interface 2respectively on Switch A and Switch B to verify the connectivity between two switches.The IPv6 prefix in the EUI-64 format is 2001::/64. Specify the aggregatable globalunicast address of Switch A as 3001::1/64, and the aggregatable global unicastaddress of Switch B as 3001::2/64.II. Network diagramFigure 1-6 Network diagram for IPv6 address configurationIII. Configuration procedurez Configuration on Switch A
