Operation Manual – IPv6 RoutingH3C S7500E Series Ethernet Switches Chapter 2 IPv6 RIPng Configuration2-102.4.4 Configuring the Maximum Number of Equal Cost Routes for LoadBalancingFollow these steps to configure the maximum number of equal cost RIPng routes forload balancing:To do... Use the command... RemarksEnter system view system-view ––Enter RIPng view ripng [ process-id ] ––Configure the maximum number ofequal cost RIPng routes for loadbalancingmaximumload-balancing numberOptional4 by default2.5 Displaying and Maintaining RIPngTo do... Use the command... RemarksDisplay configurationinformation of a RIPng processdisplay ripng[ process-id ]Available in anyviewDisplay routes in the RIPngdatabasedisplay ripng process-iddatabaseAvailable in anyviewDisplay the routing informationof a specified RIPng processdisplay ripng process-idrouteAvailable in anyviewDisplay RIPng interfaceinformationdisplay ripng process-idinterface [ interface-typeinterface-number ]Available in anyview2.6 RIPng Configuration ExampleI. Network requirementsAs shown in Figure 2-4, all switches run RIPng. Configure Switch B to filter the route(3::/64) learnt from Switch C, which means the route will not be added to the routingtable of Switch B, and Switch B will not forward it to Switch A.II. Network diagramFigure 2-4 Network diagram for RIPng configuration
