Operation Manual – Link AggregationH3C S7500E Series Ethernet Switches Chapter 2 Link Aggregation Configuration2-4Note:z You can remove any service loop group except those that are currently referencedby modules.z For a service loop group containing only one port, the only way to remove the portfrom it is to remove the service loop group.2.1.5 Entering Aggregation Port Group ViewIn aggregation port group view, you can make configuration for all the member ports ina link aggregation group at one time.Follow these steps to enter aggregation port group view:To do… Use the command… RemarksEnter system view system-view ––Enter aggregation port group view port-group aggregation agg-id ––Caution:In aggregation port group view, you can configure aggregation related settings such asSTP, VLAN, QoS, GVRP, Q-in-Q, BPDU tunnel, MAC address learning, but cannot addor remove member ports.2.2 Displaying and Maintaining Link AggregationTo do… Use the command… RemarksDisplay the local systemID display lacp system-id Available in any viewDisplay detailedinformation about linkaggregation for thespecified port or portsdisplay link-aggregationinterface interface-typeinterface-number [ tointerface-typeinterface-number ]Available in any viewDisplay information aboutthe specified or all serviceloop groupsdisplay link-aggregationservice-type [ agg-id ] Available in any viewDisplay summaries for alllink aggregation groupsdisplay link-aggregationsummary Available in any view
