Handling Static-Sensitive DevicesAttention: Adapters, planars, diskette drives, and disk drives are sensitive to staticelectricity discharge. These devices are wrapped in antistatic bags to prevent thisdamage.Take the following precautions:v If you have an antistatic wrist strap available, use it while handling the device.v Do not remove the device from the antistatic bag until you are ready to install thedevice in the system.v With the device still in its antistatic bag, touch it to a metal frame of the system.v Grasp cards and boards by the edges. Hold drives by the frame. Avoid touching thesolder joints or pins.v If you need to lay the device down while it is out of the antistatic bag, lay it on theantistatic bag. Before picking it up again, touch the antistatic bag and the metalframe of the system at the same time.v Handle the devices carefully to prevent permanent damage.Stopping the SystemAttention: When shutting down your system to install options, shut down allapplications first and then shut down the operating system. The system power turns offand the system goes into standby mode when the operating system is shut down.Before removing power from the system, ensure that the shutdown process is complete.Failure to do so can result in the loss of data. Some option installation procedures donot require the system to be stopped for installation. If necessary, the option installationprocedures in this section will direct you here if stopping the system is required.1. Log in to the system as root user.2. Stop any applications that are running on the system.3. At a command line, type shutdown to stop the operating system.4. After you shut down the operating system, set the power switches of any attacheddevices to Off.248 Service Guide
