- 36 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setPreparations for Putting the FLS 106 Scanner into12ServicePreparations for the Safe Operation of the FLS 106 Scanner12.1There are two options to ensure the system's safe operation: use the SUH 106 safety enclosure orprovide for a spatial separation (see Section 6.1).When choosing the place of installation, consider which of the aforementioned safety solutions is tobe implemented.Setting Up the FLS 106 Scanner12.2Only remove the protective film after setting up the FLS 106 scanner at its place of installation.The scanner dimensions are 1,030 x 775 x 990 mm and its weight is 75 kg.There is thus an increased risk of injuries when carrying or moving the scanner.Do not carry or move the scanner alone.The FLS 106 scanner may only be used in closed rooms under appropriate light conditions.Take the space requirements for cordoning off the area into account if you intend to operate thesystem with a spatial separation.The scanner should be installed on a raised surface such as a table, workbench, etc. Check theworktop's size and load-bearing capacity before installing the system.Ensure that the worktop is large enough and its load-bearing capacity is not exceeded (total weightincluding the SUH 106 approx. 125 kg) if you intend to operate the system with the SUH 106 safetyenclosure.Make sure that the free working area around the scanner is large enough for the scanner to behandled properly.The scanner should be set up on a level, firm and clean surface. Secure thescanner against slipping and falling down if there is a risk of it slipping. There isan increased risk of injuries due to the scanner's high weight.After setting up the scanner at its place of installation, remove the protective film by hand. Do notuse any tools such as knives, cutters or scissors to remove the protective film. There is a risk thatsharp-edged, metallic tools cause damage to the system, such as scratches on the scanner ordamage to the insulation of cables or to persons by cuts.
