- 59 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setInstalling an ICR Near-Field Microprobe17Laying the Connecting Cables17.1Unscrew the two screws of the cable holder on the rotary ring and place the upper part of the cableholder on one side (see Figure 70).Figure 70: Unscrewing the cable holderScrew the short SMA-SMA RA measuring cable to the SMA coupling (Figure 71) and then lay it onthe rotary ring as shown in Figure 71.Connect the SSMB-SSMB cable to the SSMB connector on the left side of the rotary unit below theSMA coupling (Figure 73) and lay it on the rotary ring as shown in Figure 74.Figure 71: Connecting the SMA-SMA measuring cable Figure 72: SSMB connector on the rotary unit
