Langer FLS 106 IC User Manual

Also see for FLS 106 IC: User manual

Contents

Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
Declaration of Conformity
General Remarks
Description of Symbols
Scope of Delivery
Technical Parameters
Technical Parameters of the Subassemblies
GND 25 Holder
GND 25 Ground Plane
SUH 106 Safety Enclosure
Requirements for the ChipScan-Scanner Software
Intended Use
Risks if Not Used for Its Intended Purpose
Hazard Due to Movements along the Axes
Safety Devices
Environmental Protection
Overview of the FLS 106 Scanner
Guide Rails along the Y-Axis (Long Side)
Gantry
Aluminium Mounting Bracket
T-Slot Table
Control Panel with EMERGENCY STOP Device and Control LEDs
ON / OFF Switch
Connectors on the Control Panel
Connector for External Emergency Stop Switch or Safety Enclosure
Overview of Attachments
DM-CAM with Camera Screw
Clamping Pieces
SH 01 Probe Holder
Delivery
Preparations for Putting the FLS 106 Scanner into Service
Removing the Transport Protection from the Guide Rails
Checking / Releasing the EMERGENCY STOP Switch
Putting the FLS 106 Scanner into Service for the First Time
Installation
Checking the Cables of the Rotary Unit
Installing the Digital DM-CAM Microscope Camera
Installation of the Digital DM-CAM Microscope Camera on the FLS 106 PCB
Connecting a Computer
Switching the FLS 106 Scanner on
Software Installation
Installing the ChipScan-Scanner Software
Putting the FLS 106 Scanner into Service with the ChipScan-Scanner Software
Fastening the Device Under Test
Fastening a Circuit Board with the UH DUT Universal Holder
Installing the UH DUT
Fastening the GND 25 Ground Plane for IC Measurements
Information on Using the GND 25 Ground Plane
Installing an ICR Near-Field Microprobe
Connecting the ICR Near-Field Microprobe
Installing the BT 706 Bias-Tee
Installing a Near-Field Probe with the SH 01 Probe Holder
Connecting a Near-Field Probe Directly to the FLS 106 IC Scanner
Connecting a Near-Field Probe With a Pre-Amplifier
Installing a Near-Field Probe on the FLS 106 PCB
Connecting a Near-Field Probe Directly to the FLS 106 PCB Scanner
Collision Control for the Near-Field Probe
Information on How to Operate the FLS 106 Scanner
Estimating the Duration of a Measurement with the FLS 106 Scanner
After Completing the Measurement
Removing a Device Under Test from the T-slot Table
Maintenance
Dismantling/Disposal
Customer Service
Warranty

Langer FLS 106 IC User Manual Manual pdf 68 page image

- 68 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setFigure 98: Pre-amplifier example Figure 99: Pre-amplifier on the scanner's "RF in" inputConnect the near-field probe's RF measuring cable to the pre-amplifier's SMA input (Figure 100).Connect the pre-amplifier's power supply cable to the "12 V DC" connector of the Z-axis tower(Figure 101).Figure 100: RF measuring cable connected to the pre-amplifierFigure 101: Pre-amplifier power supply cable in theconnected stateInstalling a Near-Field Probe on the FLS 106 PCB18.2Begin by fastening the SH 01 probe holder to the aluminium mounting bracket with the knurledscrews M3.Figure 102: Mounting the probe holder on the aluminium mounting bracket

/ 79

This manual is suitable for:

FLS 106 IC FLS 106 PCB

manualsdatabase

Your AI-powered manual search engine