- 75 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setRemoving a Device Under Test from the T-slot Table21.5First loosen the clamping pieces (screws M6, hexagon socket 5 mm) and then remove the deviceunder test from the T-slot table.Removing a Circuit Board from the UH DUT21.6After loosening all attached claws (claw 01 and/or claw 02) (screw M3, 2.5 mm hexagon socket),remove the circuit board from the UH DUT universal holderRemoving the UH DUT21.7First loosen the clamping pieces (screws M6, hexagon socket 5 mm) and then remove theUH DUT from the T-slot table.Removing the GND 2521.8Grasp the edge of the GND 25 ground plane that is installed on the GND 25 holder with bothhands and raise it.Removing the GND 25 Holder21.9Unscrew the two screws M6 (hexagon socket 4 mm) to remove the GND 25 holder. Then raise theGND 25 holder and remove the T-nuts from the T-slot table via the T-slot openings.Removing the DM-CAM Microscope Camera21.10Disconnect the HR10 plug from the HR10 connector marked "Camera" on the scanner's Z-axistower. Release the plug's quick-action coupling to do so.Then loosen the small, silver-coloured knurled screw and pull the microscope camera out fromabove.You can also remove the camera screw from the DM-CAM holder.3 camera holder if required.Loosen the large, silver-coloured knurled screw on the rear of the DM-CAM holder.3.Removing the DM-CAM Holder.3 Camera Holder21.11You can also remove the DM-CAM holder.3 from the rotary unit if required.Loosen the two knurled screws M4 on the top of the rotary unit for this purpose.
